Waldorf AFB 16 User Manual - The User Interface
Waldorf ROT Analog Filter Step Sequencer VST Plug-In
19
AFB16 User´s Manual
The User Interface
The ROT user interface corresponds to the internal design
of the AFB16, and can be considered as a remote control
for the filter hardware. The following sections explain the
individual functions and parameters in detail.
The Operating Controls
All controls can be manipulated using the mouse.
Display
: shows the active
parameter and its current
value. The display is also where you will find the
parameter name and corresponding numeric value of any
control you move the cursor over.
Knobs
: clicking and dragging the mouse button
around a knob will set the value of that knob’s
parameter. Using a wider circular motion will
allow you to make more subtle changes. The
ROT display will update to show you the parameter you
are editing and its current value.
Buttons:
are activated and deactivated by
clicking them with the mouse. An activated
button will be lit up in red.
Value Selectors:
to change a value click on the
control and move the mouse up or down while
holding the button.
Faders:
click on a fader and pull it up or down
while holding down the mouse button.
Waldorf Logo:
opens a
window with information
about the plug-in.
Key Combinations
•
While holding down the [CTRL] button on your
computer keyboard ([CONTROL] on Mac), clicking
on a parameter will reset the value to its default
setting (e.g. Resonance will become 0, Cutoff Mod
will become 0%, etc.)
•
[ALT] + click ([OPTION] + click on Mac) changes a
value’s selection mode from circular to linear (and
vice versa).
•
Other special key combinations for ROT are
explained in the next sections of this manual.