Waldorf PC8140G Installation And Operation Manual - page 14
Operation
12
Lighting Pilot Burner
1.
With pasta cooker tank full of water, pilot burner can be lit.
2.
Check gas supply is turned ‘On’ at mains supply.
3.
Depress and rotate gas control knob to ‘PILOT’ position and hold knob depressed.
4.
Open front access door and depress piezo igniter located on bulkhead panel, until pilot burner
ignites.
5.
Continue holding gas control knob depressed for approx. 10 to 15 seconds after igniting pilot burner,
then release, pilot burner should remain alight.
6.
Ensure pilot burner is alight, by checking that pilot flame is alight with access door open.
7.
If pilot burner does not ignite, repeat Items 1 to 6 above.
Lighting Main Burner
1.
Depress and rotate gas control knob to ‘High Flame’ position, main burner will ignite automatically
off pilot burner.
2.
Gas control knob can be regulated between 'High Flame' and 'Low Flame' position to regulate
cooking temperature.
3.
It will take approximately 30 minutes to heat water in tank from 20°C to 100°C.
Turning 'Off' the Pasta Cooker
To the ‘Pilot’ Position
a. Depress and rotate gas control valve clockwise to ‘Pilot’ position.
b. Main burner will extinguish and ‘Pilot’ will remain alight.
To the ‘Off’ Position
a. Depress and rotate gas control valve fully clockwise to ‘Off’ position.
b. ‘Pilot’ burner will extinguish.
Do NOT ignite burner if tank is empty (No Water). Ensure tank is filled to
correct level before igniting main burner.
Caution
IMPORTANT:
Should any abnormal operation like;
- ignition problems,
- abnormal burner flame,
- burner control problems,
- partial or full loss of burner flame in normal operation, be noticed, appliance requires
IMMEDIATE service by a qualified service person and should not be used until such service
is carried out.