Waldorf RN8110G Installation And Operation Manual - page 12
10
Operation
Lighting the Pilot Burner - (Target Top)
1.
Remove centre casting with casting removal tool.
2.
Depress control knob and rotate anti-clockwise to ‘PILOT’ position.
3.
With control knob depressed, manually light pilot burner located in front of main burner.
4.
Hold in control knob for approximately 10 to 15 seconds, then release.
5.
Pilot burner should remain alight. If not repeat Items 2 to 4 above until pilot burner lights.
Lighting the Main Burner - (Target Top)
1.
Ensure pilot burner is alight by checking through hole in centre of front control panel or by removing
centre casting with casting removal tool.
2.
Rotate gas control knob anti-clockwise to ‘HIGH’ position.
3.
Main burner will ignite automatically from pilot burner.
4.
Once lit, main burner will be burning at full rate. For a lower heat turn gas control knob fully anti-
clockwise to ‘LOW’ position.
5.
Also for intermediate heat, position gas control knob between ‘HIGH’ and ‘LOW’ positions.
NOTE: Always set gas control knob to ‘HIGH’ position when lighting main burner. If pilot burner
goes out during normal operation wait 5 minutes before relighting.
6.
The cast iron work surface has a heat pattern that can be used effectively by positioning cooking
pans etc. appropriately according to heat requirement.
350 / 400
300 / 350
250 / 300
200 / 250
Heat Pattern for target top on full heat (°C)
Heat Pattern for target top on Low Heat (°C)
200 / 250
150 / 200
250 / 300
Fig 4
Fig 5