Waldorf RN8910G Installation And Operation Manual - page 14
12
Operation
Lighting the Oven Pilot Burner
This oven is fitted with a pilot as a standard option and flame
failure protection, which is incorporated by way of a thermo-
electric system for main burner. Flame failure protection will
shut off gas supply to burner should pilot burner go out, so that
un-burnt gas is not expelled.
This is an important safety
feature which is slowly becoming law throughout the
world
.
1.
Open oven door. Partially depress thermostat control
knob whilst turning anti-clockwise to ‘Pilot’ position. DO
NOT fully depress Control Knob whilst trying to
rotate anti-clockwise as Knob and Gas Valve will
be damaged.
2.
With thermostat control knob in ‘Pilot’ position, keep
knob depressed whilst pressing piezo igniter button.
(Each press of piezo igniter button will generate a single
spark).
3.
Hold in thermostat control knob for approx. 10-20
seconds, then release. Pilot burner should remain alight.
(If pilot does not light, repeat Items 1 to 3 above).
4.
View oven pilot burner through holes in front of sole
plate with oven door open.
Lighting the Oven Main Burner
1.
Ensure pilot burner is alight.
2.
Rotate thermostat control knob anti-clockwise to desired
temperature marked on knob.
3.
Main burner will ignite automatically, from pilot burner.
Turning the Oven to ‘Stand-by’ (Pilot ‘ON’ Only)
NOTE: DO NOT attempt to rotate T
hermostat
Control Knob
anti-clockwise back to ‘Pilot’ position as Knob and
Gas Valve will be damaged.
1.
Rotate thermostat control knob clockwise to ‘Pilot’
position. Main burner will extinguish and pilot burner will
remain alight.
Pilot Burner
viewing holes
Fig 4
DO NOT USE aluminium foil or trays directly on cast iron
sole plate(s). NEVER block or cover openings on each
side of sole plate(s).
! IMPORTANT
Control Knob in
Pilot Position
Depress and Rotate Knob
Anti-Clockwise to Pilot Position
Piezo Igniter
Button
Control Knob in Main
Burner Operating Position
Rotate Knob Anti-Clockwise
to Operating Temperature
Control Knob in
Pilot Position
Rotate Knob Clockwise to Pilot Position
Piezo Igniter
Button