Waldorf RN8910G Installation And Operation Manual - page 21

19 

Gas Conversion and Specifications

Gas Regulator 

- NAT Gas / LPG / Butane Only. 

NOTE: 

Gas regulator supplied is 

convertible between Natural Gas 

and LP Gas, but it’s outlet 

pressure is fixed ex-factory and 

is NOT to be adjusted. 

- Town Gas Only. 

1. 

Remove slotted cap from regulator. 

2. 

Turn ‘On’ gas supply and appliance. 

3. 

Adjust pressure adjusting screw to achieve correct burner 

operating pressure. 

NOTE:  Measure operating pressure at manifold test point 

with two burners operating at 'High Flame' setting. 

4. 

Verify operating pressure remains correct (Re-adjust regulator 

if required). 

5. 

Screw cap nut back onto regulator. 

Gas Type Identification Label 

On completion of gas conversion, replace gas type identification label located at:- 

- Rear of appliance, above gas connection. 

- Beside the rating plate. 

Commissioning 

Before leaving the installation; 

1. 

Check all gas connections for leakage using soapy water or other gas detecting equipment. 

2. 

Carry out a ‘Commissioning’ check of appliance as shown in Installation Section of this manual. 

3. 

Ensure any adjustments done to components that have adjustments / settings paint sealed are to be 

re-sealed. 

NOTE, Pin rotated 

for Natural Gas 

NOTE, Pin rotated 

for LPG 

Pressure Adjusting 

Screw 

Cap Nut 

D

O

NOT

USE

A

NAKED

FLAME

TO

CHECK

FOR

GAS

LEAKAGES

. 

Warning