Waldorf RN8910G Installation And Operation Manual - page 23

21 

Gas Conversion and Specifications

 - All Other Markets: 

NOTE: 

(*) Measure Burner operating pressure at manifold test point with two burners operating at 

'High Flame' setting. 

NAT, LPG & Butane Only - Operating pressure is ex-factory set and is not to be adjusted, 

unless when converting between gases, if required. 

(**) TOWN GAS Only - Adjust burner operating pressure using adjustable gas regulator 

supplied. 

Refer to information in this section for further details. 

Natural Gas 

Town Gas (**) 

Open Burner 

Main Burner 

Ø 2.45mm 

Ø 4.50mm 

Pilot Burner ('PF' Option Only) 

0.30 0.60 

Oven 

Main Burner 

Ø 2.6mm 

Ø 5.0mm 

Pilot Burner 

0.35 0.60 

Low Fire 

Ø 1.5mm 

Ø 2.50mm 

Burner Aeration Setting 

Fully Open 

Fully Open 

Supply Pressure 

1.13 - 3-4 kPa 

0.75 - 1.50 kPa 

Burner Operating Pressure (*) 

0.95 kPa 

0.63 kPa 

Gas Regulator Cap Screw 

Adjustable Regulator 

(Adjust to Burner Operating 

Pressure specified). 

LP Gas (Propane) 

Butane 

Open Burner 

Main Burner 

Ø 1.50mm 

Ø 1.40mm 

Pilot Burner ('PF' Option Only) 

0.20 0.20 

Oven 

Main Burner 

Ø 1.60mm 

Ø 1.45mm 

Pilot Burner 

0.23 

Low Fire 

Ø 0.95mm 

Burner Aeration Setting 

Fully Open 

Supply Pressure 

2.75 - 4.50 kPa 

Burner Operating Pressure (*) 

2.6 kPa 

Gas Regulator Cap Screw