Waterway NEO 2100 Instruction Manual - Warning!
WARNING!
Qualified Technician Required for Service and Installation
BASIC INSTALLATION AND CONFIGURATION GUIDELINES
• Use minimum 6AWG copper conductors only.
• Readily accessible disconnecting means to be provided at time of installation.
• Permanently connected power supply.
• Connect only to a circuit protected by a Class A Ground Fault Circuit Interrupter (GFCI) or Residual Current Device (RCD)
mounted at least 5’ (1.52M) from the inside walls of the spa/hot tub and in line of sight from the equipment compartment.
• CSA enclosure: Type 2
• Refer to Wiring Diagram inside the cover of the control enclosure.
• Refer to Installation and Safety Instructions provided by the spa manufacturer.
WARNING!
People with infectious diseases should not use a spa or hot tub.
WARNING!
To avoid injury, exercise care when entering or exiting the spa or hot tub.
WARNING!
Do not use a spa or hot tub immediately following strenuous exercise.
WARNING!
Prolonged immersion in a spa or hot tub may be injurious to your health.
WARNING!
Maintain water chemistry in accordance with the Manufacturers instructions.
WARNING!
The equipment and controls shall be located not less than 1.5 meters horizontally from the spa or hot tub.
WARNING! GFCI OR RCD PROTECTION.
The Owner should test and reset the GFCI or RCD on a regular basis to verify its function.
continued next page
SAVE THIS MANUAL
PLEASE MAKE IT AVAILABLE TO ALL OTHER SPA USERS
SPA CONTROL SYSTEM
2