1. DL manuals
  2. Wayne-Dalton
  3. Garage Door Opener
  4. Torquemaster 9100
  5. Installation Instructions And Owner's Manual

Wayne-Dalton Torquemaster 9100 Installation Instructions And Owner's Manual

Manual is about: Torsion Spring

Summary of Torquemaster 9100

  • Page 1

    Garage doors & openers part no. Important notices! Wayne-dalton highly recommends that you read and fully under- stand the installation instructions and owner’s manual before you attempt this installation. To avoid possible injury, read the enclosed instructions carefully before installing and opera...

  • Page 2

    2 please do not return this product to the store. Contact your local wayne-dalton dealer. To find your local wayne-dalton dealer, refer to your local yellow pages business listings or go to the find a dealer section online at www.Wayne-dalton.Com a. Flag angles (as required): a1. Fully adjustable (f...

  • Page 3: Warning

    Important safety instructions definition of key words used in this manual: warning warning indicates a potentially hazardous situation which; if not avoided, could result in severe or fatal injury. Caution: property damage or injury can result from failure to follow instructions. Important: required...

  • Page 4: Warning

    Drawbar operator bracket pull down rope (if included) stud plate (as required) (2) 3/8”- 16 hex nuts 1/4”- 20 flanged hex nuts (as required) (2) 5/16” washers (2) 5/16”-18 hex nuts 1/4”-14 x 7/8” self drilling screws (as required) 5/16” x 1 5/8” hex head lag screws (as required) 1/4”-20 x 11/16” sel...

  • Page 5

    Of the jamb, fit the weatherstrip up tight against the temporarily attached weatherstrip in the header and 1/8” to 1/4” inside the jamb edge. Temporarily secure the weatherstrip with equally spaced nails. Repeat for other side. This will keep the bottom section from falling out of the opening during...

  • Page 6

    Installation before installing your door, be certain that you have read and followed all of the instruc- tions covered in the pre-installation section of this manual. Failure to do so may result in an improperly installed door. Note: reference tds 160 for general garage door terminology at www.Dasma...

  • Page 7

    Please do not return this product to the store. Contact your local wayne-dalton dealer. To find your local wayne-dalton dealer, refer to your local yellow pages business listings or go to the find a dealer section online at www.Wayne-dalton.Com place the center jamb bracket over the lower hole of th...

  • Page 8: Warning

    Please do not return this product to the store. Contact your local wayne-dalton dealer. To find your local wayne-dalton dealer, refer to your local yellow pages business listings or go to the find a dealer section online at www.Wayne-dalton.Com strut top rib bottom rib lock, intermediate(s) or top s...

  • Page 9

    Please do not return this product to the store. Contact your local wayne-dalton dealer. To find your local wayne-dalton dealer, refer to your local yellow pages business listings or go to the find a dealer section online at www.Wayne-dalton.Com vertical track assembly jamb bracket flag angle flag an...

  • Page 10: Warning

    Please do not return this product to the store. Contact your local wayne-dalton dealer. To find your local wayne-dalton dealer, refer to your local yellow pages business listings or go to the find a dealer section online at www.Wayne-dalton.Com (2) #12 x 1/2” phillips head screws 1/4”- 14 x 5/8” sel...

  • Page 11

    Please do not return this product to the store. Contact your local wayne-dalton dealer. To find your local wayne-dalton dealer, refer to your local yellow pages business listings or go to the find a dealer section online at www.Wayne-dalton.Com top section horizontal track bottom of strut short stem...

  • Page 12: Warning

    Please do not return this product to the store. Contact your local wayne-dalton dealer. To find your local wayne-dalton dealer, refer to your local yellow pages business listings or go to the find a dealer section online at www.Wayne-dalton.Com securing center bracket bushing assembly tools: power d...

  • Page 13: Warning

    Please do not return this product to the store. Contact your local wayne-dalton dealer. To find your local wayne-dalton dealer, refer to your local yellow pages business listings or go to the find a dealer section online at www.Wayne-dalton.Com winding spring turn chart door height spring turns 6’-0...

  • Page 14

    Please do not return this product to the store. Contact your local wayne-dalton dealer. To find your local wayne-dalton dealer, refer to your local yellow pages business listings or go to the find a dealer section online at www.Wayne-dalton.Com perforated angle sound framing members horizontal track...

  • Page 15: Warning

    Torquemaster ® plus reset instructions tools: ratchet wrench, 5/8” socket, 3” socket extension, 5/8” wrench, (2) vice clamps, step ladder important: the drawbar operator force settings must be adjusted according to the manufacturer’s instructions. Some lighter weight doors are designed to operate wi...

  • Page 16: Warning

    Drawbar operator hook-up chart,standard lift for 12” and 15” radius operator models type of arm being used ref. Illustrations quantum/classic curved / straight fig 6 linear straight / curved fig 5 liftmaster (sears) curved / straight fig 6 genie curved / straight fig 6 or fig 5 drawbar operator hook...

  • Page 17

    Loosely fasten step plate slide to base with (1) 1/4”-20 x 5/8” carriage bolt and nut. Align inside step plate holes and fasten from inside using the #8 screws provided. Install one #8 x 3/4” screw in the bottom step plate hole. The screw in the top hole varies with door models. Use the screw size s...

  • Page 18: Warning

    Cleaning your garage door important: do not use a pressure washer on your garage door! While factory-applied finishes on garage doors are durable, it is desirable to clean them on a routine basis. Some discoloration of the finish may occur when a door has been exposed to dirt-laden atmosphere for a ...

  • Page 19

    Lifetime limited warranty models 9100, 9400, 9600 subject to the terms and conditions contained in this lifetime limited warranty, wayne-dalton, a division of overhead door corporation (“manufacturer”) war- rants the sections of the door, which is described at the top of this page, for as long as yo...

  • Page 20

    After installation is complete, fasten this manual near the garage door. Please do not return this product to the store thank you for your purchase. Contact your local wayne-dalton dealer. To find your local wayne-dalton dealer, refer to your local yellow pages business listings or go to the find a ...