WBS AV6201A openGear User Manual - page 8
Board Installation
Use the following procedure to install the AV6201A in an openGear OG3FRC Series frame.
1. Refer to the User Manual of the openGear OG3FRC series frame to ensure that the frame is
properly installed according to instructions.
2. When using the AV6201A with the T6301A for maximum I/O, please note that the even
numbered slots are to be used. Plug the AV6201A modules into slots 2,4,6,8,10,12,14,16,18,
and 20 for a maximum of 10 cards. Slot 1 is the left most slot as you look into the frame from
the front.
3. When using the AV6201A with the T6401A for maximum density, you may insert the card into
any slot for up to 20 cards per frame.
4. After selecting the desired frame installation slot, hold the AV6201A card by the edges and
carefully align the card edges with the slots in the frame. Then fully insert the card into the
frame until the rear connection plugs are properly seated on the midplane and rear module.
This completes the procedure for installing the AV6201A in an openGear OG3FRC Series frame.