Web Direct Estate Swing User manual - page 10
Changing Administrator Pass Code from Default:
Programming via phone call:
The system only allows the 3 administrator numbers as authorized user to change the 6 digits password.
To change the password from the factory default 123456 to 654321 (Example) you can just call the unit and when the unit replies,
you can use the following commands using the keypad prompts on your telephone.
Once the call has connected … (With a short beep ~ prompt the administrator to enter password, the initial set up password is
123456 by default)
After enter password… (Another short beep ~Password Correct)
Press *2# (A short beep ~ success)
Then input the current password 123456# (you should hear a short beep ~success)
Continue to enter new password 654321# for 2 times (another short beep if password entered correctly)
If the change has not been successful you will hear 3 beeps and must re-enter again.
Programming via Text Message (SMS)
Example:
Sends a SMS Command: *PAWO#654321
If the change is successfully, the system will display “OK” on the screen and the administrator will receive a reply message from
the unit.
Returned Message:
PAWO-OK
Resetting forgotten password
In the event the password is forgotten or cannot be accessed, you can send the following SMS to the unit and the system will be
reset to factory default as *123456#
Sends the SMS Command *REST#615858 and the unit will reply REST-OK and the password is now back at factory default as
*123456#
To manually reset the unit, you can press and hold on the “Call” button and turn on the unit for 10 seconds. The unit will displays
Wait… and then OK, the unit is reset.