Web Direct Estate Swing User manual - page 7
Programming Administrator umbers:
Administrator codes:
Administrators can program the system, open the gate via cell phone and receive the phone calls from the
gate call box.
Programming via phone call:
The administrator numbers can be programmed individually or all in
one call
using the following [Example numbers are (1111558888),
(2222669999), and (3333770000) - substitute real phone num-
bers in your programming]. Only
one administrator needs to be established to begin using the system.
Example:
Once the call has connected… (With a short beep ~ prompt the ad-
ministrator to enter password, the initial set up password is 123456
by default)
After enter password… (Another short beep ~ Password Correct)
Press *3# (you should hear a short beep ~ success)
Continue press 1# to add the first administrator number (another
short beep ~ success)
Then enter the administrator number 1111558888# (you will hear a
short beep ~ the administrator number is setup successfully)
Continue...
Press *3# (you should hear a short beep ~ success)
Continue press 2# to add the second administrator number (another short beep ~ success)
Then enter the administrator number 2222669999# (you will hear a short beep and the number has been
changed to 2222669999
Continue...
Press *3# (you should hear a short beep ~ success)
Continue press 3# to add the third administrator number (another short beep ~ success)
Then enter the administrator number 3333770000# (you will hear a short beep and the number has been
changed to 3333770000
If the change has not been successful you will hear 3 beeps and must re-enter again.
Programming via Text Message (SMS) on next page.
Diagnostic display read out below