Webasto Air Top Evo 40 Installation Instructions Manual - page 9
9
Air Top Evo 40 | Air Top Evo 55
3.4 Installation position
3.5 Installing heater
0-90°
0-90°
0-90°
Fig. 03: Permissible installation position of diesel heater
0-30°
0-90°
0-90°
Fig. 04: Permissible installation position of petrol heater
X
X
Make sure that the installation location satisfies the require-
ments.
X
X
Ensure the correct installation position.
X
X
Comply with vehicle manufacturer's instructions.
X
X
Unevenness >1 mm: Flatten out support surface.
X
X
Drill holes with the aid of the drilling template (see „13 Annex“).
Fig. 05: Base seal for heater
X
X
Fit base seal between heater and support surface.
X
X
Except for the year of installation, remove all the year numerals
on the type label and type label duplicate.
X
X
Secure heater at base with M6 nuts.
X
X
Tighten nuts to a torque of 6 Nm.
X
X
Make sure that the heater rests only on the base.
Fig. 06: Example of rating plate duplicate
X
X
If the type label is not visible after installing the heater: Secure
the type label duplicate such that it is clearly visible in a protec-
ted area on the vehicle.
WARNING
Exhaust fumes
Poisoning and suffocation
X
X
Make sure that the casing rests only on the base
after installation.
X
X
Make sure that the base seal is fitted correctly.
X
X
Make sure that the exhaust gasses are routed only
to the outside.
The support surface for the heater base must be flat.
The base seal compensates for unevenness of up to
1 mm.