Weewell WMA440 User Manual - Switch On The Baby Unit

14

Switch on the Baby unit 

1. To switch on, press . 

 The Green Link light comes on to show 

that the unit is within range of the Parent unit. 

Switching off both units 

1. To switch Off, press 

 until the display goes blank and the link 

light goes off. Please note, if there is an alert displayed, you will 

need to press the button twice.

Changing Baby unit from battery to mains 

power 

To conserve battery power on the Baby unit or when the batteries 

are low or flat, plug the Baby unit into the mains. If currently 

running on batteries and switched on, changing from battery to 

mains power will be instant and not affect any of the settings.

You can use the Parent unit to monitor baby while it is charging.

Adjust speaker volume

There are 5 volume levels (and off ) on the Parent unit. 

The volume level is shown on the display bars, e.g. level 3 is 

shown 

1. Press 

  or 

 . The volume level is displayed.

Changing the volume setting on the Baby unit affects the volume 

Helpline

If you have any problems using your 

WMA440 Baby Monitor 

Please visit www.weewell.com 

If you place the Parent and Baby units

too close together you will hear a high

pitched noise, this is normal. The units

are designed to be located at a distance 

from one another, e.g. in separate rooms.

Do not press the Talk button when the 

Baby unit and Parent unit are positioned 

in the same room. High - pitch noise will 

be generated if the Talk button is pressed 

when Baby unit and Parent unit are close 

to each other or within 3 metres distance.

Put down  mute the Parent unit before 

you go into the nursery in order to prevent 

any high-pitched whistle feedback.