Wega Mininova Instruction Manual - page 11
11
11
12
13
14
INSTALLATION
When delivered from the factory, the machine is ready for two types of installation: Pouring water into
reservoir or connecting to your main water supply.
1 - Functioning with built-in water tank.
Remove the top cover and make sure that the feeding tube is well positioned in the bottom of the tank;
fill tank with 2 liters of water. Replace the cover.
Warning: when there is no water in the tank the machine will work only after adding more water.
2 - Installation with plumbing into main water supply:
- remove hose from built-in water tank and feed through inside of machine to base of machine and
out.
- remove two screws from top of machine; take off top of machine. (fig. 01)
- There is a switch to the right of the machine.
When connecting hose to main water supply, the switch should be in the “1” position. (When using
the built-in tank as your water supply the switch should be in the “0” position).-connect hose to main
water supply. (we recommend to use a water softener).
Important: Due to variations in water pressure, we hyghly recommend a pressure breaker between
the machine and the main line. Otherwise you may experience leaking in the valves. The technician
will be able to supply you with this part.
Check the supply pressure with a filter holder with manometer (optional). Then reduce the above-
mentioned pressure to the normal supply value using the adjustment screw placed on the pump end
(fig. 15). The pressure reduction is got rotating the screw anticlockwise.
Insert the plug into a 220V socket (110V if the machine is allowed for this voltage).
Turn on the machine by pushing the general switch (fig. 03). You will hear the machine feeding
automatically water into the boiler.
22
Stop
Prog
O
I
O
I
01
02
07
09
08
10
03 04
05
06
15
16
MININOVA EPU-EVD:
Eine äusserst kompakte Expressomaschine mit Handbedienung durch einen Druckknopf (MININOVA
EPU) oder durch automatische Portionierung (MININOVA EVD). Eine professionelle Gruppe mit
Magnetventil die nach dem Prinzip des Heisswasserumlaufes funktioniert. Fassungsvermögen des
Heizkessels 2 Liter. Der Heizkessel ist mit einem Wärmeaustauscher ausgerüstet, der "sauberes"
Wasser abgibt. Es besteht die Möglichkeit des Anschlusses ans Wassernetz, oder die Verwendung
eines eingebauten Wassertanks. Sicherheitsvorrichtung bei Wassermangel. Elektrische Speisung
einphasig 220 oder 110 Volt auf Bestellung, Leistungsaufnahme 1500W. Abmessungen: Tiefe 45 cm,
Breite cm 30 und Höhe cm 38.
01 - Deckel mit Tassenablage
02 - Druckknopf für Heisswasser
03 - Hauptschalter
04 - Druckknopf Kaffeeausgabe
05 - Manometer
06 - Dampfhahn
07 - Heisswasserrohr
08 - Wassersammelwanne
09 - Siebträger
10 - Dampfrohr
11 - Drücktaste 1 Tasse
12 - Drücktaste 2 Tassen
13 - Drücktaste Dauern-Stop
14 - Drücktaste Program
15 - Pumpe Einstellung
16 - Überdrücksventil