Weider PRO 125 User Manual - page 6
3
4
2.
Insert two M10 x 70mm Bolts (19) through the holes
in the Support Plate (27) and then through the indi-
cated holes in the Main Frame (1).
Slide the bracket on the Leg (6) onto the two M10 x
70mm Bolts (19). Tighten two M10 Nylon Locknuts
(18) onto the Bolts.
Press a Square Bushing (22) onto the lower end of
the Leg (6). Press a 25mm Square Inner Cap (24)
into the tube on the Leg.
3.
Locate the second Stabilizer (2) and note the inden-
tations around the holes. Insert two M10 x 72mm
Carriage Bolts (21) through the holes in the
Stabilizer so that the bolt heads fit into the indenta-
tions.
Slide the bracket on the Adjustment Leg (7) onto
the two M10 x 72mm Carriage Bolts (21) in the
Stabilizer (2). Tighten an M10 Nylon Locknut (18)
onto each Bolt.
Press a 60mm Round Endcap (10) onto each end
of the Stabilizer (2).
4.
Slide the Adjustment Leg (7) up into the Leg (6).
Line up one of the holes in the Adjustment Leg with
the indicated hole in the Leg.
Insert the Adjustment Knob (23) into the holes in
the Leg (6) and the Adjustment Leg (7). Fully tighten
the Adjustment Knob into the indicated welded nut.
7
6
19
1
6
18
24
22
18
7
18
10
27
2
1
7
6
Welded
Nut
Hole
23
2
21
10
6
7
5.
Attach a 30mm x 25mm Bumper (26) to the indicated
hole in the Main Frame (1) with a Bumper Screw
(25).
Press a 25mm x 50mm Inner Cap (14) into the indi-
cated end of the Backrest Frame (4).
Hold the opposite end of the Backrest Frame (4)
inside the indicated bracket on the Main Frame (1).
Attach the Backrest Frame to the Main Frame with
an M10 x 80mm Bolt (17) and an M10 Nylon
Locknut (18). Do not overtighten the Nylon
Locknut; the Backrest Frame must pivot easily.
6.
Note that the bracket on the Backrest Frame (4)
has four sets of oval holes and one set of round
holes. Hold the 15mm x 10.5mm x 67mm Spacer
(28) between the round holes in the bracket. Insert
an M10 x 85mm Bolt (29) through the bracket and
the Spacer. Tighten an M10 Nylon Locknut (18)
onto the Bolt. Make sure that the Spacer is under
the Main Frame (1).
Insert the Locking Pin (16) through one of the four
sets of oval holes in the bracket on the Backrest
Frame (4) and through the welded tube in the Main
Frame (1) (the welded tube is not shown in this
drawing; however, it is shown in drawing 5).
7.
Attach the Backrest (8) to the brackets on the
Backrest Frame (4) with four M6 x 16mm Screws
(15).
17
14
1
25
26
Bracket
18
4
29
16
4
5
8
15
4
15
1
Round
Hole
Oval
Adjustment
Holes
Welded
Tube
28
18