Workrite SEHX30-48 series Assembly & Installation Manual - ✓
10 of 10
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
#1500272 Rev C
Cleaning Instructions
To clean the Sierra legs, apply cleaner to a soft cloth.
Suggested cleaners: Windex or Formula 409.
Do not use solvents and do not saturate or spray cleaners directly onto workcenter base.
✓
Parts & Accessories
Visit
http://workriteergo.com/documentation/other/workrite_ergonomics_pricing_specification_guide.pdf
for
replacement parts.
✓
Put Workcenter Upright and Connect Power Cord to the Power Supply
Turn the workcenter over into an upright position.
Plug the Power Cord (O) into the power outlet.
Initialize Legs
After all Legs and the Switch are connected, and the power cord has been plugged in, hold the
down arrow on
the Switch until the Legs make a short motion down and then back up. This initializes and synchronizes the
workcenter Legs.
Adjust Feet Glides
If necessary, adjust the Foot Glides (H) on workcenter feet to level the worksurface. Unscrew to increase height,
screw in to decrease height.
You must complete this
initialization step or your
workcenter will NOT
function properly.
Hold down the down arrow
until workcenter moves slightly
upwards!
Download and Install Sierra HX Interface Kit Software
Visit
http://workriteergo.com/support/sierra-interface/
to download
and install the Sierra Interface software. You will also find an
installation guide for the Sierra Interface Kit Hardware (P) and a User
Guide to get the most out of the Interface Kit.
Sierra Interface Kit Cable (P)
O
a
b
11
12
13
b
a
14