Workrite SEHX30-48 series Assembly & Installation Manual - page 5
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
5 of 10
Attach Base to Non-Workrite
Worksurface
Note: For 2-Leg Corner and 120° Worksurface
Mounting Instructions, go to:
www.workriteergo.com/instructions
Position Leg Assembly
2.875" from the sides and
6.125" from the front of the
worksurface, making sure the
legs are parallel with the back
edge of the worksurface.
Use a ⅛" drill bit to drill
pilot holes at the four corner
locations. You may wish to
mark your drill bit so you
do not drill any more than
¾" deep and damage your
worksurface top.
Do not
drill all the way through
worksurface!
Attach at the four corner locations using #12 × ¾" Pan Head Laminate Top Screws (G). If you use an electric
screwdriver, be sure it is on the lowest torque setting to avoid stripping the holes in the top.
With frame set positioned and the four corner screws secure, drill pilot holes first then attach the frame set using
the remaining #12×¾" Pan Head Laminate Top Screws (G).
Do not drill all the way through worksurface!
>¾"
6.125"
2.875"
2.875"
6.125"
23"– 30"
Parallel t
o edge
c
d
front
4
a
b
a
a
b
b
b
b
Note: Avoid trip or tip hazards!
For uniquely shaped, non-rectangular worksurfaces, it is the
installer's responsibility to position the worksurface to minimize
extended overhangs and position feet fully under the worksurface.
3 screws per
Short Bracket
2 screws per End Bracket
(2 installed in Step 4c)
c
c
d
d
c
c
G
#12 × ¾" Pan Head
Laminate Top Screw
Hardware at actual size
G
G
G
G