Workrite SEHX30-48 series Assembly & Installation Manual - page 6
6 of 10
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Attach Feet (sold separately) & Install Foot Glides
Install Feet using #M6 × 14 mm Flat Head Cap Screws (F) included
with this Frame Set.
Attach Foot Glides (H) to bottom of the Feet supplied in your Foot
Kit.
Attach Switch
Install your switch using two #8 × 5/8" Pan Head Screws (L).
Note: You may have purchased a Programmable Switch which
attaches in the same manner.
Loop Power Cord through Strain Relief on Control Box
Loop the Power Cord (O) through the strain relief
channel on the bottom of the Control Box (I) as
shown. Leave eight inches of slack to route cord.
Plug Power Cord (O) into power outlet AC on the
Control Box (I).
Lay the Control Box down in installation location
with cables in place.
Standard Switch
Programmable Switch
or
8"
8"
a
a
b
b
b
5
6
H
H
F
Flat Foot shown
Programmable Switch shown
F
#M6 × 14 mm Flat Head
Cap Screw
Hardware at actual size
Caution!
Only use the #M6 × 14 mm Flat Head
Cap Screw (F) for assembly.
O
O
I
I
7
b
b
a
a
bottom
L