Workrite SEHX30-48 series Assembly & Installation Manual - page 8
8 of 10
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
48" Tables
32" & 40" Tables
Attach Cable Loops and Route Cables
Connect both of the 1 meter Leg Cables (N) to both Legs (A).
Wind any remaining slack around Cable Spools (K) to keep cables out of the way while leaving enough slack to
just reach the Control Box (I).
Attach Cable Loops (M) to underside of worksurface using #8 × ⅝" Pan Head Screw (L) making sure to wrap the
Cable Loop around the cable prior to attaching. If you do not have a Workrite worksurface, attach cable loops in
convenient locations between Legs or Switch and the Control Box.
L
#8 × ⅝" Pan Head
Screw
I
K
K
K
A
A
A
A
b
b
b
b
a
a
a
a
a
c
9
L
M
M
L
Hardware at actual size
c
c
Note: For smaller workcenters, it may be
easier to wrap cable around Spools (K)
prior to plugging into Legs (A).