Workrite SEHX30-48 series Assembly & Installation Manual - page 7
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
7 of 10
Attach Control Box & Cable Spools to Worksurface
Position Control Box (I).
If you have a Workrite worksurface:
Locate the two pilot holes for the Control Box and proceed to
Step 8b.
If you do not have a Workrite worksurface:
Place Control Box (I) in position and use a pencil to mark pilot hole placement. Control Box should be placed
towards rear center of worksurface as shown. Remove Control Box and drill pilot holes where marked.
Do not drill all the way through worksurface!
With Control Box (I) positioned over pilot holes, attach with two #12 × 2" Flat Head Screws (J).
Attach Cable Spool (K) with the #12 × ¾" Pan Head Screw (G) to underside of worksurface. If you do not have a
Workrite worksurface, mount Cable Spools (K) in a convenient location between Legs and Control Box.
Lay out Leg Cables (N) to be sure they reach from the Legs (A) to the Control Box (I).
48" Tables
32" & 40" Tables
a
a
a
b
c
d
d
d
d
d
c
c
c
b
b
8
I
I
G
K
K
K
G
G
J
J
J
J
N
N
N
N
G
#12 × ¾" Pan Head
Laminate Top Screw
J
#12 × 2" Flat Head Screw
Hardware at actual size
Hardware at actual size