Xenarc 700TSH Installation Manual - page 10
10
│ Hardware Installation
Buttons description:
1.
Power Button : Press to turn ON or OFF the monitor.
2.
Select Button : Press to select the input signal to display.
Press the left ( ◄ ) or right ( ► ) to highlight the input source
desired and then press menu button to make the selection.
3.
Menu Button : Press the button to show the OSD menu.
And then press the left ( ◄ ) or right ( ► ) to navigate through
the menu.
Press “ Select ” button to go through a list of settings and
options.
Press the left ( ◄ ) or right ( ► ) buttons to change the values
of settings.
Press Menu button again to leave the OSD menu.
4.
Right Button : Press this button to increase volume or the value
of settings inside the OSD menu.
5.
Left Button : Press this button to decrease volume or the value
of settings inside the OSD menu.
Ambient Light Sensor Description
Ambient light sensor can be enabled or disabled in the OSD by going
into the “ MISC ” category, and selecting the option “ Auto Sensor ”.
When Auto Sensor is enabled, the LCD backlight brightness will be
adjusted automatically according to the ambient lighting condition.
Note
The brightness cannot be adjusted manually through the
dimmer button or through the OSD menu when the Auto Sensor
function is enabled.
OSD ( On-screen display ) Menu
Press MENU to display the OSD on the screen, then press
UP / DOWN ( or LEFT / RIGHT from the front control panel )
to highlight a different category. Press ENTER ( or Source ) to adjust
the selected highlighted category. Under the selected item page,
press UP / DOWN ( or Source ) to select the item from the list, use
LEFT / RIGHT to adjust. To select the sub-menu, please press LEFT to
enter to the sub-menu.