Xenarc 700TSH Installation Manual - page 13
13
│ Hardware Installation
5. Function
● Reset : Reset to Factory default setting.
● Display Ratio : Select the display mode to 16:9, 4:3 and Auto.
● Sleep : Select the time to automatically turn off the monitor.
The minimum is 15 minutes and the maximum is 120 minutes.
● Keypad : The function allows you to disable or enable the buttons
at the front of the monitor. Power, Menu, Select, Left, and Right
buttons can be disabled or enabled.
● Source Enable : Select to Enable or disable the input signal. If
an input signal is turned off, the source will be disabled.
● Touch Controller : Switch the power source for touch control board.
6. Sound
● Volume : Adjust the audio volume of built-in speaker.
● Mute : Enable or disable muting of built-in speaker.
● HDMI Input : Select the audio source while in HDMI input mode.
When set to HDMI, the built-in speaker will output the digital
audio signal from HDMI.
When set to Analog, the built-in speaker will output the analog
audio signal from the mini stereo jack marked as “ PC Audio ”
※
The HDMI output option is only available for TSH / YH models