Xenarc 700TSH Installation Manual - page 12
3. OSD
● H Position : Adjust the OSD Horizontal position by pressing the left or
right buttons.
● V Position : Adjust the OSD Vertical position by pressing the left or
right buttons.
● OSD Timeout : Adjust the time out of the OSD.
● Transparent : Adjust the transparency of the OSD screen image.
4. Setup
● CCD First : Set whether to have monitor switch to CCD signal
automatically if a signal is present. ( Default is OFF )
● Source Info : Select to turn OFF or turn ON displaying of On Screen
Source Information.
● Source Name : Display the source of input signal. If it is ON, it will
display the information on the left corner of the screen when Display
button is pressed on remote control. ( Default ON )
● Mirror Hor : Adjust the horizontal mirroring position. If it is ON, the
image will be on the left and right side. ( Default OFF )
● Mirror Ver : Adjust the vertical mirroring position. If it is ON, the
image will be on the upper and lower side. ( Default OFF )
12
│ Hardware Installation
● Auto sensor : Enable or disable the auto sensor of surrounding
environment.
─“ On ” means the monitor can automatically adjust the brightness of
the display according to the surrounding environment.
─Please note : While auto sensor is enabled, the option of dimmer or
backlight inside the OSD can not work until auto sensor is disabled.