Xeoos Twinfire Basic Operating And Installation Instructions - page 5
5
Required Installation Components
A Chimney cap
B Triple skinned chimney
C Storm collar
D Roof flashing
E Ceiling support box
F Chimney connector pipe
Installation of the Stove
Heating Capacity and Space Requirements
The room-heating capacity is highly dependent on the room’s location and interior as well as on
the operation method. In a newer air-tight building be prepared to calculate your heat demand.
In older buildings, the nominal heating capacity of approximately 27kBTU’s (8 kW’s) heats an
area from 430 - 1,076 ft
2
(40 -100 m
2)
based on various conditions.
Outside Air Supply
Ensure that there is sufficient combustion air in the room in which the stove is installed, and that
there is an adequate supply of combustion air to the stove, which can be sourced from another
room or from an outside air supply. Rooms with negative pressure (e.g. use of exhaust fan) or
newer air-tight buildings are particularly suited for air supply from outside..
Connection to the Chimney
The Twinfire stove can only be flued from the top outlet in Clean Air
Zones. A rural, rear flued model can be made available.
The diameter of the stove pipe is 6” (15.2 cm). Do not use
connector pipes and chimneys with smaller clearance diameters or
less than 24 gauge steel (0.55mm). It must be installed using an
AS/NZS 2918:2001 approved chimney system or a code-approved
masonry chimney with a flue liner.
The chimney must extend through the roof for an assembled length
not less than 4m and be 600mm above any high section of roofing or
adjacent obstruction. If there is no obstruction or ridge within 3m the
flue must not be lower than the point at roofline 3m horizontal to the
flue center (see detail)
The condition of the chimney and height is very important. We
suggest a total minimum height of 4.8m where practical.
To reach the rated heat capaci-
ty, the minimum delivery pres-
sure of the chimney must be 10
to 15 Pa (1.0 to 1.5 mm WC).
Follow the rules and regula-
tions in your local area.
IT IS VERY IMPORTANT TO ENSURE THAT YOUR CHIMNEY HAS A GOOD
DRAFT. YOUR DEALER OR CHIMNEY SWEEP WILL BE ABLE TO GUIDE
AND ADVISE YOU ON YOUR CHIMNEY CONDITIONS.
A
D
C
B
B
E
F