Xerox Color 1000 System Administration Manual - page 15

3

Test Print option

The Test Print option is available only when you are logged on as Administrator. The

Test Print option is available with all Advanced Stock Setup options. Please read the

following information before using the Test Print option.

• It is recommended that you choose only one option at a time, and then run a set of

test prints to evaluate the output. This helps you determine whether or not that

option is providing the desired printed output.

• If you determine that the output is unacceptable after running test prints, either

further adjust the value for a particular option (if applicable) and run more test prints

or return the option to its default value and continue to the next option.

• If you want multiple Advanced Stock Setup options selected, individually select each

option, run Test Prints, and evaluate the output. After you determine that the output

for the selected option is acceptable, then you can select another option to adjust.

• It is important to remember that any settings for a particular option that is used

today for a specific print job may not achieve the same desired outcome/output

when used on different day for that same print job. This is especially relevant if the

room in which the machine is located experiences changes in temperature and

humidity.

• You may need to continually repeat procedures and test prints for any Advanced

Stock Setup option until you achieve acceptable output prints.

• If you determine that your output still is unacceptable after repeating procedures

and test prints multiple times, call your Customer Support Center for help/assistance.

Related Topics:

Test Print option for 2nd Bias Transfer Roll

Using the Test Print option

3-1

Xerox

®

 Color 800i/1000i Presses Xerox

®

 Color 800/1000 Presses

System Administration Guide