Xerox Color 1000 System Administration Manual - page 68
11. Measure the sample output and record both c-fold positions on a sheet of paper.
12. Enter the measurement values that you obtain during the previous step in the “A”
Length window and/or the “B” Length window by using the up/down arrow buttons.
13. Select the Start button.
A Test Print status button is displayed while the print process occurs.
Upon completion of the test prints, the following window appears:
14. Select either:
a) Done Adjusting: Select this if the output meets customer satisfaction.
This closes the current window and returns you to the main Fold Adjustment
window. The new/edited fold adjustment profile is displayed in the Fold Adjustment
window.
b) Continue Adjusting: Select this if the output does not meet customer satisfaction
and requires further adjusting.
This returns you to the The Fold Adjustment - Test Print window where you can
make further adjustments and run additional test prints. Repeat this step as
required until the desired output is achieved. The new/edited fold adjustment
profile is displayed in the Fold Adjustment window.
15. Select Close to exit Profiles and return to the main UI.
16. Select Logoff to exit the Administrator mode.
Related Topics:
Xerox
®
Color 800i/1000i Presses Xerox
®
Color 800/1000 Presses
6-18
System Administration Guide
Profiles