Xerox DocuCentre SC2020 User Manual - page 220
Tools
Xerox
®
DocuCentre
®
SC2020
User Guide
217
5.
Select [Panel Lock].
6.
Select [Panel Lock Set].
7.
Select [Enable], and then select [OK].
8.
Enter the new passcode, and then select [OK].
Note:
The factory-default panel passcode is 0000.
–
Be sure to remember the passcode. The procedure described below allows you to reset the
passcode, but the settings for Address Book are cleared.
–
Turn off the device. Then, while holding the
–
If you change the passcode while [Panel Lock Set] is [Enable], perform steps 1 to 3. Enter the
current passcode, and then select [OK]. Perform steps 4 and 5. Select [Change Passcode], and
then select [OK]. Enter the current passcode, and then select [OK]. Perform steps 8 and 9. This will
change the passcode.