Xerox DocuMate 4830 User Manual - page 160
Xerox
®
DocuMate
®
4830
User’s Guide
160
When this option is available, it is an advanced user and application option and should not be adjusted if you are
not familiar with the technology. However, if you are certain that you are using an application that can receive a
compressed image, and you want to be able to change the image compression type, you will need to enable user
adjustable compression in the scanning interface. Please refer to the
Driver Settings
section for instructions.
Please note that if you adjust this setting, and the application cannot actually accept the option you change, the
scanning interface and the application may crash. It is highly recommended that you leave the default options and
let the application set any image compression.
From the Windows Control Panel
1.
Click on the
Driver settings
tab.
2.
Select
Enable user compression
and
Remember compression
.
Note that if these two options are grayed out and you cannot select them, then these options are not available
for your scanner.
3.
Click on
OK
.
4.
Open the scanner interface.
5.
Change to the
Advanced
source configuration mode.
6.
In the Document settings section click on the
Advanced
tab.
7.
If your scanner and application supports compressed file transfers, the Compression option will now be
available.