Xerox DocuMate 510 Operator's Manual - Powering On and Off

XEROX WIDE FORMAT 510dp OPERATOR MANUAL

7

2.

Powering on and off

This chapter describes the procedures for powering on and

powering off.  It also describes the power consumption modes.

Powering on

To power on:

1.  Switch the circuit breaker to the On (I) position.  This turns on

power to the Printer.

2.  Switch the printer power switch to the On (I) position.  This

turns on the printer.

3.  Switch on the Controller.

NOTE:  During the warm-up cycle, the message display

provides a FUSER CALIBRATING message then a "printer is

warming up" message and decreasing fuser warm-up codes of

L9 to L0,.  When the warm-up completes, the printer is on-line

and ready to print.  The message display indicates, "XES

SYNERGIX 510dp IDLE."

Circuit breaker

switch

Printer power

switch

Controller

power switch