DL manuals Xerox Printer Phaser 5335 User Manual Xerox Phaser 5335 User Manual - page 114 Other manuals for Phaser 5335: Specifications, Printing Manual, Installation Manual Manual is about: Xerox Phaser 5335 Laser Printer User guide 123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172737475767778798081828384858687888990919293949596979899100101102103104105106107108109110111112113114115116117118119120121122123124125126127128129130131132133134135136137138139140141142143144145146147148149150151152153154155156157158159160161162163164165166167168169170171172173174175176177178179180181182183184185186187188189190191192193194195196197198199200201202203204205206207208209210211212213214215216217218219220221222223224225226227228229230 Page of 230 Go Download Print this page Bookmark us 96 5 Control Panel Menus [Panel Settings] Note • If you have forgotten the password, switch the printer off and restore the password to the default. 1) Switch the printer on while holding down the button. Keep holding down the button until "Reset Password. Reset?" appears on the control panel. 2) Release the button and press the button. 3) Press the button to select [Yes], and then press the button. The password is restored to the default. [Low Power Timer] System Settings Panel Settings Panel Settings Panel Lock Panel Settings Change Password Setting Item Description Panel Lock Sets a password to control access to the menus. • [Off] (default) • [On] Change Password Allows you to change the password. Enter a new password (4-digit number). The password takes effect when the first and second entries match. (default: [0000]) Note • [Change Password] is valid only if [Panel Lock] is set to [On]. • If the first and second entries do not match, your new password will not be accepted. System Settings Low Power Timer Setting Item Description Low Power Timer Sets the amount of time before the printer enters the Low Power mode. Specify the value in 1 minute increments. (See *2 on P. 111.) • [1 Minutes] to [60 Minutes] (default: [3 Minutes]) Refer to • "2.4 Setting/Exiting the Power Saver Modes" (P. 27) • "Setting Example: Changing the Power Saver Mode Setting" (P. 76) « ‹ Prev111112113114115116117Next › »