Xerox Wide Format 6604 User Manual - page 138
Calibrate Touch Screen
Your User Interface Touch Screen is calibrated when it is installed. Calibration aligns the
cursor to the place on the screen that you touch. The user interface does not typically
need to be recalibrated, unless it is not working correctly or you reinstall the controller.
1. Press the Services button on the Control Panel.
The Services menu screen displays.
2. Select Machine Info from the Services menu screen.
The Machine Info screen displays.
3. Select the Administration tab.
4. Select Control Panel.
5. Select Calibrate Touch Screen.
6. Press and hold your finger on the calibration symbol in each corner of the screen until
it moves to the next corner. It will touch all four corners.
7. Once the symbol moves to all four corners, the user interface prompts you to touch
anywhere on the screen to save the calibration data.
8. The User Interface saves the calibration data and displays the Control Panel screen.
Network Setup
Prior to being able to communicate with your FreeFlow Accxes scanner and printer, the
FreeFlow Accxes controller needs to be configured to the network.
The Network Setup settings allow the System Administrator to setup the following
TCP/IP settings:
• IP Address
• Gateway
• Submask
• DHCP
If you do not know the above information, perform the following steps to generate a
Configuration Report:
1. Select Machine Info on the Services menu.
2. Select the Print Reports tab.
3. Select Printer Configuration.
Instead of entering the IP Address, Subnet Mask, and Gateway Address, you may
enable Dynamic Host Configuration Protocol (DHCP) on the Network Setup screen.
For more information on DHCP, see the Setting Up DHCP section of this chapter for
details.
Xerox
®
Wide Format 6604/6605 Solution
™
5-20
User Guide
System Administrator