XIEGU X5105 Instruction Manual - page 16
16
B.
Use a multi-function microphone for frequency setting
Press the [F-INP ENT] button on the cursor, and the X5105 enters the frequency setting.
The cursor appears on the left of the frequency display bit.
Enter the desired frequency value in turn, and then press [F-INP ENT] button again to
complete the frequency setting.
For example, set the current frequency to 51.050000MHz, and press the order as
follows:
First, press the [F-INP ENT] button.
Please press the 51.050000 numeric key in turn.
Once again press the [F-INP ENT] button to complete the settings.
3.9 Start the ATU (automatic antenna tuner) into the tuning function
X5105 transceiver built-in an efficient automatic antenna tuner, which can help you easily
complete the erection and debugging of the antenna.
Press the [ATU] button for a long time, it will start the ATU auto tuning function. When
the tuning is complete, the host will automatically return to the receiving state.
3.10 RIT (receive frequency trimming)
Relative to the set frequency, the RIT function can set the offset value of the actual
receiving frequency of the maximum
±
5kHz.
Operation method:
A.
Press [RIT] button to start RIT function.
B.
The rotating knob can change the receiver frequency in the range of
±
5kHz. The
screen has the corresponding area to display the frequency change value.
C.
If you want to turn off the RIT function, press the [RIT] button again. When the RIT
function is enabled again, the last RIT setting will still be used.
D.
If you want to clear the RIT offset, in the RIT open state, turn the knob and set the
offset to zero.
If the frequency offset range more you want, you can use pilot frequency transceiver
mode. Please refer to the VFO instructions for details.