Xoro HTC 1946 HD User Manual - Main Menu
HTC 1946 & HTL 4346
25
E
ng
lish
Procedure for the manual station search:
Use the ▲ / ▼ buttons from the first satellite, you want to set.
Press the OK button. An arrow appears before the selected satellite. The arrow causes the
satellite will be considered at the next station search.
Press the ► button twice to switch to the right side.
Using the ▲ / ▼ buttons to select the different settings, use the buttons
◄ / ► to change this.
Have you adjusted the settings for the satellite, press the EXIT button and then ◄ to switch
back to the left side.
Can you receive with your reception system more satellites, select now the ▲ / ▼ another
satellites, press the OK button for this, and then make the settings on the right side in front.
Repeat steps for all satellites that you can receive with your antenna system.
Notes:
In the lower part of the menu after the settings for the selected satellite have been carried out
correctly and a transponder in the middle, the approximate values for the signal quality dis-
plays.
If a satellite is not in the list, you can add it by pressing the yellow button. A window opens,
enter the values for longitude, east / west and the tape. Enter the new satellite name. If you
add a new satellite, you have the following tuning the search mode "blind search" be used.
When you add a satellite from the list, no signal quality may be displayed despite correct
settings. This indicator is only available on satellite, for a transponder list was deposited.
If one transponder in the list is missing, you can add it by pressing the yellow button. Alterna-
tively you can use the search type "blind search" to search for new stations.
For the satellite and transponder list following configuration options are available:
Red button
Deletes the selected satellite / transponder from the list
Green button
Here you can edit the receiver parameters of the selected satellite / Transpo
nders
Yellow button
Sets manually at a new satellite or transponder. Enter into this menu at the
reception parameters. With the OK button, the unit saves the settings and
created satellite / transponder appears in the list and can be searched in the
transponder scan.
Blue Taste
Starts channel search
OK
Selection / deselection
EXIT
Cancel the search