Xpresskit DBALL2 Installation Manual - page 20
Page 20
Module Programming
Refer to the LED Diagnostics section on page
for more information and for troubleshooting purposes.
26
Go to the next page t complete the module programming.
o
Note for Knob style vehicles:
Before starting the programming sequence, remove the metal key by sliding it out from the
. The
OEM FOB
removal of the knob cover is necessary.
1- With the start knob in the
position, remove the auxiliary key from the advanced key.
OFF
2- Remove the cover of the start knob by pulling it outward while pressing both buttons on each side of the knob.
3- Proceed to module programming below.
Important
Make all the required connections to the vehicle, as described in the wiring diagram(s) found in this guide, and double check to
ensure everything is correct prior to moving onto the next step.
Warning!
To take advantage of advanced features, you must use Xpress
4.5 (and higher) or the Directechs Mobile app.
VIP
When the flashing operation is successful, you can proceed with the programming instructions below.
OR
If required for your installation, connect the 10-pin, 12-pin and 14-pin harnesses to
the module, then connect the 4-pin D2D harness.
D2D Installation
W W Installation
2
If required for your installation, connect the 10-pin and 12-pin harnesses to the
module, then connect the 14-pin harness to the module.
10-pin
D2D
1
st
12-pin
14-pin
2
nd
3
rd
10-pin
D2D
1
st
4
th
12-pin
14-pin
2
nd
3
rd
Flashing a module using your computer:
1. Connect the interface module to your computer using the
XKLoader2.
2. Go to www.directechs.com using Internet Explorer, and
select the
button.
Flash Module
3. Follow the instructions to select your vehicle, installation
type, and configure your options.
4. Once you have configured the firmware options, click on the
FLASH button.
Flashing a module using your smartphone or tablet
1. Connect the interface module to your
oader3.
XKL
2. Launch the Directechs Mobile app on your smartphone or
tablet.
3. Select
and follow the on screen
FLASH YOUR MODULE
instructions.
Rev.: 20170926
Platform: DBALL2
Firmware:
MA2
© 2017 Directed. All rights reserved.