1. DL manuals
  2. Xpresskit
  3. Remote Starter
  4. XK09
  5. Installation Manual

Xpresskit XK09 Installation Manual

Other manuals for XK09: Installation Manual
Manual is about: CHRYSLER Remote Start Ready Installation

Summary of XK09

  • Page 1

    Vehicle compatibility chart wiring diagram. ......................................................................................................................................... Installation procedure overview..........................................................................................

  • Page 2

    Vehicle compatibility chart page 2 to see a list of available features for each vehicle, visit www.Xpresskit.Com. Vehicle application guide 2 0 0 5 2 0 0 4 2 0 0 3 2 0 0 2 2 0 0 1 2 0 0 0 chrysler pt cruiser x x x x x dodge dakota x x x x durango x x x neon x x x x x x ram x x x x x ram srt-10 x sx ...

  • Page 3

    Please note: failure to proceed in the following order could result in possible vehicle damage. If your remote start system has d2d jumpers, make sure both jumpers are in the horizontal operating position. Installation procedure overview 4 3 2 see details on page 5. Module programming power up the x...

  • Page 4

    Programming button xk09 front side wiring diagram page 4 xk09 back side 10 01 20 11 20 pin connector wire side view blue/white red/white light green blue (-) ground when running (status)* (-) trunk* (-) lock* (-) unlock* (+) 12 volt* (-) ground* black red +12vdc xkloader2 option a - firmware upgrade...

  • Page 5

    Vehicle type neon 1 pt cruiser 1 ram (with oem alarm only) 2 dakota 3 durango 3 vehicle type programming vehicle type chart page 5 on start off key remove key 5 turn the key to the off position and remove it from the ignition barrel. 1 once all the wires are properly connected, plug the wire connect...

  • Page 6

    User configuration - optional programming 1 insert the key into the ignition at the off position and hold the programming button down for at least 2 seconds. The led flashes rapidly for 2 seconds to confirm you are in programming mode. & flash 2 secs & on start off key press & hold key at off 6 remo...

  • Page 7

    Led status description troubleshooting during power up solid red module not programmed. Data bus is not detected. Make sure the connections to the data bus are correct by referring to the wiring diagram, and then turn the ignition to the on position. In rare cases, the vehicle w ill need to be start...

  • Page 8

    This interface kit / data bus interface part has been tested on the listed vehicles. Other vehicles will be added to the select vehicle list upon completion of compatibility testing. Visit website for latest vehicle application guide. Disclaimer: under no circumstances shall the manufacturer or the ...