Xpresskit XK09 Installation Manual - page 3
Please Note:
Failure to proceed in the following order could result in possible vehicle damage.
If your remote start system has D2D Jumpers, make sure both Jumpers are in the
horizontal operating position.
Installation Procedure Overview
4
3
2
See details on page 5.
Module programming
Power up the XK09
Once done, the interface red LED will turn ON.
If connected in W2W
Connect the 20-pin harness.
If connected in D2D
Connect the 4-pin D2D harness first,
then connect the 20-pin harness.
Caution! The 20-pin connector can be easily plugged in backwards.
1
Make the necessary connections in the vehicle, as instructed in the
vehicle-specific guides.
Connect the remote starter to the vehicle
Make all the connections as per the provided wiring schematics,
either in W2W or D2D.
Wiring
Page 3
Rev.: 20100302
Platform: XK09
Firmware: DLCH3
© 2010 Directed Electronics. All rights reserved.