Xpresskit XK09 Installation Manual - page 5
Vehicle
Type
Neon
1
PT Cruiser
1
RAM (with OEM Alarm Only)
2
Dakota
3
Durango
3
Vehicle Type Programming
Vehicle Type Chart
Page 5
ON
START
OFF
KEY
Remove Key
5
Turn the key to the OFF position and remove it from the ignition barrel.
1
Once all the wires are properly connected, plug the wire connector into the module.
The LED turns ON.
On Solid
&
Press & Release
3
To change the vehicle type, press and release the Programming button until the
LED flashing pattern matches the desired type.
For instance: 1 flash = Type 1, 2 flashes = Type 2 and so on.
Flashing Pattern
2
Insert the key into the ignition barrel and turn it to the IGN position.
The LED turns OFF, then begins a flashing pattern that matches the vehicle
type selection (the default type is 1).
If the module has NEVER been programmed or has been RESET, the LED
will indicate which type the module is in by the number of flashes.
ON
START
OFF
KEY
Key at IGN
Off
&
Flashing Pattern
&
4
To save the vehicle type selection, press and hold the Programming button until
the LED flashes once rapidly. The module will then exit the Programming mode
and is ready to be used.
If the LED turns ON solid, turn the key to start the engine.
If the module has already been programmed, the number of flashes
indicates once only the programmed type when applying power to the
module.
&
Press & Hold
Flashes Once
Rev.: 20100302
Platform: XK09
Firmware: DLCH3
© 2010 Directed Electronics. All rights reserved.