Xpresskit XK09 Installation Manual - page 7
LED
Status
Description
Troubleshooting
During Power Up
Solid red
Module not programmed.
Data bus is not detected. Make sure the
connections to the data bus are correct by
referring to the wiring diagram, and then turn
the ignition to the ON position.
In rare cases, the vehicle w ill need to be
started in order to detect the bus.
Flashes continuously
by increments of one
Chrysler Neon & PT Cruiser will be selected
for programming.
Must press and hold the Programming button
for 3 seconds to select a type.
Flashes once then
turns off
Chrysler Neon & PT Cruiser have been
successfully programmed.
N/A
Flashes continuously
by increments of two
Dodge RAM will be selected for programming.
Must press and hold the Programming button
for 3 seconds to select a type.
Flashes twice then
turns off
Dodge RAM has been successfully
programmed.
N/A
Flashes continuously
by increments of three
Dodge Dakota & Durango will be selected for
programming.
Must press and hold the Programming button
for 3 seconds to select a type.
Flashes thrice then
turns off
Dodge Dakota & Durango have been
successfully programmed.
N/A
In Operating Mode
Solid red
Incorrect behavior.
Data is not being processed. Remove power
from the module, make sure the connections
to the data bus are correct by referring to the
wiring diagram, and then power up.
Flashes 1 second
A D2D or W2W command is being
processed.
N/A
Connect to
RAM (2001-03) Connect to
RAM (2004-05):
:
Dark purple/Light blue wire in kick panel located under dash on driver side.
Light green/Orange wire in kick panel located under dash on driver side.
Tech Notes for Violet/Brown Wire
LED Diagnostics
Make sure this wire is connected as indicated below.
With Factory Alarm
With or Without Factory Alarm
Connect to Light green/Orange wire in kick panel located under dash
on driver side.
PT Cruiser (2000-05) Connect to White/Green wire coming from the driver door at the side kick panel.
Neon (2000-05): Connect to Light green wire kin kick panel located under dash on driver side.
* The BCM in the Dodge Dakota may go to sleep a minute after the doors have been locked and closed. If this happens a
ground pulse to the driver door pin switch (Tan in DKP) before unlock will wake-up the BCM and the doors will unlock.
Dakota* (2001-04) & Durango (2003 & earlier):
:
It is important to select the correct alarm option (mode 7) that corresponds to the vehicle you are currently performance
the installation on. See page 6 for more information on mode selection.
Page 7
x1*
x2*
x3*
x1
sec
* In this instance of the module diagnostics, the LED flashes in a continuous sequence.
x1
x2
x3
Rev.: 20100302
Platform: XK09
Firmware: DLCH3
© 2010 Directed Electronics. All rights reserved.