Xray T1R Racer Instruction Manual - page 11
10
LON
GER
SHO
RTE
R
309343
SFH M3x6
Identify the nylon holders used to mount the front lower arms
to the front bulkheads; they are marked for easy
identification. Also identify the holes in the front bulkheads
where you will mount the lower arms.
1
1.. Mount lower suspension holders
and
to the
inside rear of the bulkheads, using #309336 (SH M3x12)
screws. The holes in the holders point toward the front.
2
2.. Slide a #307214 pivot pin through the holes
in the two front lower arms. Position the front
suspension arm in the front bulkhead.
3
3.. Insert the lower suspension holders
and
to
the pins on the right and left arms, respectively. Mount the
holders to the bulkheads using #309336 (SH M3x12)
screws. Use the middle hole in each front bulkhead as
shown.
309336
SH M3x12
1.6 mm
Use front MIDDLE hole
LLoow
weerr FFrroonntt SSuussppeennssiioonn H
Hoollddeerrss
Right rear: Holder 3
Left front: Holder 3
Right front: Holder 2
Left rear: Holder 2
FRONT TRANSMISSION
The left and right front lower arms are mirror images.
Thread a #309358 (SB M4x8) downstop adjustment screw into the hole at the rear of
each front lower arm. The screws must protrude 1.6 mm below the arms, and must be
accessible from the tops of the arms for adjustment.
309358
SB M4x8
1
1.. Mount the right front bulkhead to the lower
chassis using three #309343 (SFH M3x6)
screws.
2
2.. Place remaining differential inside the front
end of the long drive belt. Make sure the
differential is oriented so the shorter diff output
shaft is near the right front bulkhead.
3
3.. Insert the shorter output shaft of the
differential into the ball-bearing in the right front
bulkhead.
4
4.. Slide the left front bulkhead into position over
the other end of the differential, and mount to
the lower chassis using three #309343
(SFH M3x6) screws.
➊
➊
➋
➌
➌
➋
➊
➋
➌
➍
B
OTTOM
T
OP
F
RONT
F
RONT
➊
➌
F
RONT
➊
➌
Refer to the Set-Up Book to gain a better
understanding of anti-dive.