Xray T1R Racer Instruction Manual - page 22
21
1
1.. Mount the wheels on the wheel axle hex hubs using #309310 (SH M4x8) screws
and #309310 (ST 4x12) cone washers. Note the orientation of the cone washer in
the detail image. M
Maakkee ssuurree tthhee w
whheeeell ssccrreew
wss aarree vveerryy ttiigghhtt,, ssoo tthhee w
whheeeellss ddoo nnoott
lloooosseenn dduurriinngg rraacciinngg..
This car is designed to use a 6-cell battery pack, configured into 3+3 saddlepacks.
2
2.. Remove the clips from the front of the battery mounting
posts, and pivot the battery straps open.
3
3.. Position the battery pack in the chassis cutouts.
4
4.. Reposition the battery straps over the batteries,
and secure to the front battery mounting posts
with the clips.
The XRAY T1R Raycer is a competition racecar, and therefore does not
come supplied with tires and inserts. Check with racers at tracks you
attend to determine the best tire/insert combinations.
Use your own tires and inserts to prepare the wheels:
1
1.. Install a foam insert into each tire, making sure it is centered.
2
2.. Slide the tire (with insert) onto the wheel.
3
3.. Carefully glue the tires to the wheels with CA glue.
W
Wa
arrn
niin
ng
g:: FFo
ollllo
ow
w tth
hee a
ad
dh
heessiivvee m
ma
an
nu
uffa
accttu
urreerr''ss iin
nssttrru
uccttiio
on
nss ffo
orr
p
prro
op
peerr u
ussee a
an
nd
d ssa
affeettyy.. W
Weea
arr p
prro
op
peerr eeyyee a
an
nd
d h
ha
an
nd
d p
prro
otteeccttiio
on
n..
309310
SH M4x8
309310
ST 4x12
➊
➊
➊
➋
➌
➍
➋
➌
CA GLUE
ACCESSORY ASSEMBLY
TIRES AND INSERTS
NOT INCLUDED
DETAIL