Xray T1R Racer Instruction Manual - page 18
17
301330
309452
309335
308300
309336
307464
Attach TWO rear shocks by performing
the following steps.
1
1.. Attach the top of the rear shock to the rear shock tower.
Pass a #309336 (SH M3x12) screw through a #307464
pivot ball and shock upper mount, and thread into the
indicated hole in the rear shock tower. Tighten until the pivot
ball snaps into the shock upper mount, and then tighten the
whole assembly.
2
2.. Attach the bottom of the rear shock to the rear lower arm.
Pass a #309336 (SH M3x12) screw through a #307464
pivot ball and shock lower ball joint, and thread into the
indicated hole in the rear lower arm. Tighten until the pivot
ball snaps into the shock lower ball joint, and then tighten
the whole assembly.
30 1330
REAR BODY MOUNT SET
30 7464
PIVOT BALL 5.8 MM DOUBLE BEVEL SHOULDERS (10)
30 9335
HEX SCREW SH M3x10 (10)
30 9336
HEX SCREW SH M3x12 (10)
30 9452
PIN 2x10 (10)
30 8300
XRAY SHOCK ABSORBER-SET 4-STEP (2)
Assemble TWO rear body posts by performing the following steps.
1
1.. Mount the body post to the front of the rear shock tower. The bottom
plastic pin fits into the lower hole. Use a #309335 (SH M3x10) screw to
fasten each body post to the shock tower.
2
2.. Insert a #309452 (P 2x10) pin into one of the holes in a rear body post.
Insert the other pin into the same hole in the other body post.
3
3.. Glue a rubber washer to the top of a plastic body support.
4
4.. Slide the body support onto the body post, and snap onto the pin.
8. REAR FINAL ASSEMBLY
BAG
08
309335
SH M3x10
309452
P 2x10
CA GLUE
➊
➋
➊
➋
➌
➍
309336
SH M3x12
REAR LOWER ARM
REAR SHOCK TOWER
307464
PB 5.8 mm
REAR SHOCK
(Blue spring)
Refer to the Set-Up Book to gain a better
understanding of different shock mounting locations.
INITIAL POSITION