Xray T1R Racer Instruction Manual - page 14
63 mm
13
301167
309335
307454
309010
302501
309010
309319
309336
307454
302662
302580
or
302582
302662
309336
302611
307454
309336
302630
309334
309343
309334
306500
Assemble the servo link by threading ball joints onto the ends of a
#302630 turnbuckle. The ball joints should be perpendicular (90°) to each other.
Adjust to the proper length as shown.
Note: Each turnbuckle has a CCW thread on one end and a CW thread on the other end.
30 2501
DUAL-ACKERMANN CENTRAL SERVO SAVER (SET)
30 2580
COMPOSITE SERVO HORN - KO, JR, AIRTRONICS, MULTIPLEX
30 2582
COMPOSITE SERVO HORN - FUTABA, ROBE
30 2611
ADJ. STEERING ROD L/R 35 MM - SPRING STEEL (2)
30 2630
ADJ. STEERING ROD 20 MM - SPRING STEEL (2)
30 2662
BALL JOINT 5 MM - OPEN (6)
30 6500
COMPOSITE TOP DECK MOUNT
30 7454
PIVOT BALL 5.0 MM DOUBLE BEVEL SHOULDERS (10)
30 9010
BALL-BEARING MR74ZZ 4x7x2.5 (2)
30 9319
UNIVERSAL SET OF PLASTIC SHIMS
30 9334
HEX SCREW SH M3x8 (10)
30 9335
HEX SCREW SH M3x10 (10)
30 9336
HEX SCREW SH M3x12 (10)
30 9414
E-CLIP 4 (10)
30 1167
COMPOSITE UPPER DECK
30 9343
HEX SCREW SFH M3x6 (10)
6. STEERING
1:1
FACTORY PREASSEMBLED
approx. 51 mm
BAG
06
302501
Assemble the right and left steering rods by threading #302262 ball joints onto the ends of #302611 turnbuckles.
The ball joints should be parallel with each other. Adjust to the proper lengths as shown.
Note: Each turnbuckle has a CCW thread on one end and a CW thread on the other end.
61 mm
1:1