Yale IA-210 Full User Manual - Log
19
Log
The alarm log memorises the last 30 system events
including:
· All alarm events with device names and type
· All fault warning events
· All arming and disarming events
• The logged events are displayed in reversed
chronological order (most recent event first).
• The log is marked with a ‘start’ label before the
most recent entry and ‘end’ after the oldest entry.
To view log:
1. Select the Log menu and press 3.
2. The log can now be scrolled up and down and
viewed with the st keys; the most recent event
will be at the start.
3.
The first line displays the time and date of the
event, the second line displays the type of event
and the third line either states the user or the
device that caused the event. Abbreviations used
are:
· “LB”: low battery
· “Tamp”: tamper
· “R”: restore.
· AC: mains power
· Panic: emergency
· Perimeter: entry or away entry device
· Cancel: silencing an alarm with a Panic Button
Adv. Settings
The settings will initially have factory default values.
If you do not want to change them then you can
escape any menu by pressing P without making
changes.
The following items are available in this menu:
· User PIN Code
· Entry Time
· Exit Time
· Entry Sound
· Exit Sound
· Door Chime
· Door Open/Close
· LCD Backlight
· Key Tone
· Ring Tone
· Alarm Length
· Panel Siren
· Jamming Det
· KF Entry
· Tamper Alarm
· Mobility CHK
· Siren Delay
· Warning Beep
· Time
· Date
· Supervision
· Final Door
PIN Code
The PIN Code (password) is used to configure the
Control Panel and to disarm the system.
• To disarm, press the ‘disarm’ key followed by your
PIN code.
• To enter the program menu press the ‘st’ key,
enter a PIN code followed by 3.
• Up to 6 PIN codes can be stored.
1. Select ‘PIN Code’ then press 3, a list of 6 PIN
codes will be shown, occupied codes are shown
with ****. The list can be scrolled up and down
using thest keys.
2. Select the code you want to change and press
3
, enter your new PIN code and press 3. You will
be asked to repeat the PIN code, enter it again
and confirm by pressing 3, the new code is now
programmed.
• X can be used to correct entry errors, pressing X
repeatedly will return you to the PIN code list.
• User 1 code can only be changed and cannot be
erased. All other codes can be enabled/disabled
by selecting them and pressing arm key.
• An error message will be shown if either an
incorrect repeat code is used or a duplicate code
is entered for another user. All codes have to be
different.
Entry Time
Note: Ensure device is set to entry on Control
Panel for the entry time to work (see section 5, Add
Devices)
Entry time gives you a delay to allow you time to
enter your premises and disarm the system. Times
can be set from 00 seconds (no delay) up to 70
seconds in 10 second increments.
• 20 seconds is the factory default.
Select using the selection keys, if you want to set
entry time for Away or Part Arm mode and press 3
Exit Time
Entry time gives you a delay to allow you leave you
premises before the system arms. Times can be set
from 00 seconds (no delay) up to 70 seconds in 10
19