Yale IA-210 Full User Manual - Led Illuminates and Warning
30
Voice - Dialler not responding to alarm
• Check the telephone line is connected and
that the correct telephone numbers have been
programmed.
_____________________________________________
LED illuminates and warning
beeps (every 30 seconds if
enabled)
• There is a fault condition in your alarm system.
Note: this may be a simple fault that can easily be
rectified, for example replacing low batteries in a
PIR Motion Detector.
• Please view the ‘fault log’ in the Control Panel to
determine what the issue is. This is the first option
in the programming menu. First press the ‘menu’
key and enter your user PIN code followed by
pressing 3. Select ‘fault log’ followed by 3. You
may need to scroll down using the q Key to
check if there are multiple faults in the system.
As an example, the display may read ‘DC Z01
tamper’, in which case you need to check the
mounting of the tamper spring on Door/Window
Contact zone 01 to rectify this fault. In the case of
low batteries, you may see ‘IR Z02 LB’. Replacing
the batteries in PIR zone 02 will clear this particular
fault. Other reported faults include: Interference,
Tamper, Radio Device Low Battery and AC Power
Fail etc.
• If faults has not been cleared from the ‘fault log’, a
fault display will be show when the Arm or Home
Arm keys are pressed, with the device and fault
that is causing the problem.
• If more than one fault is present then individual
fault messages will be displayed sequentially at
2-second intervals.
IMPORTANT:
Please enter the programming menu first before
swapping the batteries- otherwise you will trip the
system tamper alarm.
Press the pq and enter your user PIN code
followed by pressing 3. Stay in the programming
menu. Then, disconnect the relevant accessory and
replace batteries. If the Control Panel times out and
returns to ‘Alarm off’, please follow the above steps
again and repeat the process.
_____________________________________________
Complete Reset Procedure
Reset to factory default setting
The Control Panel can clear all programmed
parameters by the following sequence:
1. Power down Control Panel and turn off the
battery.
2. Apply power while holding down the p key.
3. Release the p key when a tone is heard, ‘Enter
Code’ will be displayed.
4. Enter the following key sequence:
pqpqpqpq
3
5. Press the X key.
6. All programmed parameters are reset to factory
default setting.
7. If more than 17 incorrect keys are entered, then
the unit will revert to normal Alarm On mode.
Note
• Once the ‘System Reset’ is executed, all the
programmed data will return to its default value
and all the programmed accessories will be
removed and the Control Panel will show the
initial set up screen. Press the learn button (see
Chapter 2 for location) on all accessories one at
a time. Every time a button is pressed, the screen
will recognise the accessory and you will need
to press OK on the panel to acknowledge/add.
Please ensure you learn in all accessories before
exiting the initial setup screen.
30