Yamaha 2012 Griizzly 700 YFM7FGPB Owner's Manual - page 24
4-5
4
EBU30490
Multi-function display
The multi-function display is equipped with the fol-
lowing:
●
a speedometer
●
an odometer
●
two tripmeters (which show the distance trav-
eled since they were last set to zero)
●
a clock
●
an hour meter (which shows the total time the
engine has been running)
●
a fuel meter
●
a self-diagnosis device
Odometer and tripmeter modes
Pushing the “SELECT” button switches the display
between the odometer mode “ODO” and the trip-
meter modes “TRIP A” and “TRIP B” in the follow-
ing order:
ODO
→ TRIP A → TRIP B → ODO
To reset a tripmeter, select it by pushing the “SE-
LECT” button, and then push the “RESET” button
for at least three seconds. The tripmeters can be
used to estimate the distance that can be traveled
with a full tank of fuel. This information will enable
you to plan future fuel stops.
TIP
Pushing and holding in the “SELECT” button, and
turning the key to “
” (on) while the button is
pushed, switches the display between “mph” and
“km/h”.
1. “CLOCK” button
2. “RESET” button
3. “SELECT” button
4. Speedometer
5. Fuel meter
6. Clock/Hour meter
7. Odometer/Tripmeter A/Tripmeter B
U1HP10E0.book Page 5 Thursday, March 24, 2011 4:11 PM