Yamaha Disklavier E3 Operation Manual - Connecting The Control Unit

8

2

Chapter

Getting Started

Note:

The cables should be connected to 

the control unit when the Disklavier 

is installed. If, however, it is not, 

carefully connect them to the 

appropriate connectors or jacks on 

the rear panel of the control unit. 

Make sure that the cables extending from the piano is connected to the 

appropriate connectors or jacks on the rear panel of the control unit.

Note:

For grand piano models, be sure to 

mount the control unit to the 

underside of the bass side key bed.

* Only for models supplied with 

the monitor speakers.

Connect the power cord extending from the power supply unit 

of the piano to the DC-IN 12V connector of the control unit.

Important:

Make sure that the voltage of the AC 

wall outlet matches that marked on 

the Disklavier’s Serial No. plate.

Connect the AC power cable extending from the piano to 

the AC wall outlet.

Connecting the Control Unit

*

Connecting the AC Power Cable

1

2