Yamaha Grizzly 700 FI Owner's Manual - V-Belt Case Drain Plug

8-42

8

7. Start the engine and rev it up approximately

twenty times while momentarily creating ex-

haust system back pressure by blocking the

end of the muffler with a shop towel.

8. Stop the engine and allow the exhaust pipe to

cool.

9. Install the purging bolt and tighten it to the

specified torque.

WARNING

EWB01930

EBU23930

V-belt case drain plug 

After riding in water deep enough to allow it to en-

ter the V-belt case, remove this plug to drain the

water from the case.

1. Purging bolt

Tightening torque:

Purging bolt:

27 Nm (2.7 m·kgf, 19 ft·lbf)

POTENTIAL HAZARD

Improperly purging the exhaust system.

Hot exhaust system.

WHAT CAN HAPPEN

Could injure the eyes.

Could cause burns.

Could cause carbon monoxide poisoning,

possibly leading to death.

Could start a fire.

HOW TO AVOID THE HAZARD

When purging the exhaust system:

Always let the exhaust system cool prior to

touching exhaust components.

Always wear eye protection, and make sure

no one is behind the ATV.

Never run the engine in an enclosed area.

Make sure there are no combustible materi-

als in the area.

U3B410E0.book  Page 42  Friday, April 14, 2006  9:13 AM