Zanussi Electrolux Electric cooker User Manaul - Electric Connection
26
ELECTRIC CONNECTION
The oven installation (electric connection, gas connection and building in) must be carried out by qualified
personnel only. The appliance must be disconnected from the electricity supply before any intervention.
Fig. 15
FO 0279
Before the appliance is connected:
1) check that the main fuse and the domestic installation
can support the load;
2) check that the power supply is properly earthed in
compliance with the current rules;
3) check the socket or the double pole switch used for
the electrical connection can be easily reached with
the appliance built in the forniture unit.
The appliance is supplied with a connection cable. This
has to be provided with a proper plug, able to support the
load marked on the identification plate. The plug has to
be fitted in a proper socket.
If connecting the appliance directly to the electric system,
it is necessary that you install a double pole switch
between the appliance and the electricity supply, with a
minimum gap of 3 mm. between the switch contacts and
of a type suitable for the required load in compliance
with the current rules.
The connection cable has to be placed in order that, in
each part, it cannot reach a temperature 50
°
C higher
than the room temperature.
After the connection is carried out, test the heating
elements for about 3 minutes.
The brown phase wire (linked to the “L” terminal of the
terminal block) must always be connected to the phase
terminal of the electric supply.
TERMINAL BLOCK
The oven has an easily accessible terminal block,
which is meant to work with an electric single-phase
rate of 230 V.
(Fig. 15)
The manufacturer disclaims any
responsability should all the safety
measures not be carried out.