Zanussi Electrolux Electric cooker User Manaul - Gas Connection
28
GAS CONNECTION
The gas supply connection ramp is positioned in the
front upper side of the oven, behind the control panel.
To carry out the gas connection, partially insert the oven
in the recess (about 30 cm.) and operate on the
connection ramp from the top. The gas connection can
be carried out in both the following systems:
1) Fig. 19 — flexible metallic pipes (with maximum
lenght up to 2 meters only) — screw the feeding
pipe to the 1/2“ connection ramp, inserting the
provided gasket between the pipe and the ramp;
2) Fig. 20 — rigid metallic pipe (soft copper Ø 8 mm)
— insert the copper pipe into the connection ramp
after fitting the provided nut and biconic ring onto
the copper pipe.
Carrying out the connection:
— Fig.21 — tighten the nuts by means of a 22 mm.
spanner, in order to keep the ramp in position and
not to cause any stretch to the gas supply circuit.
— CHECK THE PERFECT SEALING OF THE
CONNECTION USING SOAPY WATER;
— Completely insert the oven in the recess and secure
it as indicated in the relevant chapter.
Check the gas suplly ramp and the gas connection
pipe are not squeezed while the oven is positioned
into the recess.
WARNINGS
•
Using a gas cooking appliance will produce heat
and moisture in the room which it has been
installed in. Ensure a continuous air supply,
keeping the air vents in good conditions or
installing a cooker hood with discharge tube.
•
In case of intensive or long time use of the
appliance, make the ventilation more efficient,
by opening a window or increasing the electric
exhaust fan power.
Fig. 19
FO 0671
flexible
metallic pipe
gasket
Fig. 20
FO 0672
rigid
metallic pipe
biconic
ring
nut
Fig. 21
FO 0672
nut
connection pipe
gas supply
ramp