Zanussi Electrolux Electric cooker User Manaul - page 15
30
ADJUSTING THE MINIMUM FLAME
IN THE OVEN BURNER
— Disconnect the oven from the electricity supply.
— Remove the three knobs.
— Remove the discharge grid by unscrewing the fixing
screws (Fig. 23 - “A”).
— Undo the two fixing screws under the control panel
and remove it (Fig. 23 - “B”).
— With a thin screwdriver adjus the oven tap by-pass
pin (Fig. 24 - “C”).
Converting the oven from natural gas to LPG,
completely tighten the by-pass pin.
When reverting the oven to natural gas, first
completely tighten the by-pass pin, then unscrew it
of about 3/4 of a turn.
— Refit the parts by following the procedure backwards.
— Connect the oven to the electricity supply.
— Light the oven at the maximum positionand let it
warm up with the door closed for about 10 minutes,
then check that the oven burner does not go out
when quickly turning the oven knob from the
maximum position to the minimum position.
If the oven burner goes out, repeat the whole pro-
cedure.
Fig. 23
FO 1084
Fig. 24
FO 1084
A
B
B
C
A
A